Clearomiseur Prism T18E Pro – Innokin

Clearomiseur Prism T18E Pro – Innokin

Innokin

The clearomiseur Prism T18E Pro of of Innokin is equipped with a tank 2 mL. It will be ideal for beginners!

It will allow an indirect vape (MTL) in the manner of a classic cigarette and will work ideally with the battery of the  Endura T22 Pro kit  in which it is included.

Compatible with T18E and Endura M18 coils to fully enjoy the flavors of your e-liquids.

Filling of the Innokin Prism T18E Pro Clearomiser

The T18E Pro Clearomiser will be ideal to operate on the battery of the Endura T22 Pro kit for which it was specially designed, with its air intake system from below, it can however be used on other electronic boxes. It will be necessary to respect the power range of the compatible resistors (from 9 to 13.5 watts approximately).

The Innokin Prism T18E Pro Clearomiser, for which vapers?

With an indirect draw reminiscent of a classic cigarette , this material will be ideal for a beginner vaper wishing to give up his packet of tobacco. The aficionados of the so-called indirect vape (MTL) will not however be outdone with this clearomizer which can also appeal to experienced vapers for its ease of use and its characteristics allowing to find beautiful flavors, but also to vape as needed. -liquids with CBD or nicotine salts.

Composition

• 1 Prism T18E Pro 2 mL Clearomiser
• 1 T18E 1.7Ω resistor (pre-installed)
• 1 T18E 1.5 Ω resistor
• 1 spare 510 drip tip
• 1 replacement gasket
• 1 user manual

Features of the Innokin Prism T18E Pro Clearomiser

The clearomiseur T18E Pro of Innokin may contain up to 2 ml of e-liquid . Its reservoir will fill from the top by rotating the top cap (upper part on which the 510 drip tip / mouthpiece is located). The air inlet located at the bottom will provide an indirect draft (MTL) like a conventional cigarette.

The T18E Pro Clearomiser is compatible with the  T18E and Endura M18 COILS . These will allow you to fully find the flavors of your e-liquids. To change the resistance of the T18E Pro Clearomiser, you will simply have to place it upside down then unscrew the base (lower part) to access its location. The resistance will snap in the direction suggested, no need to screw. These resistors will allow you to use, if you wish, e-liquids with CBD or nicotine salts .

Direct2uvaping